Specialist Test Products > Test Jig Parts >

Desktop Test Boxes

Jig base, consisting of a pan and a hinged probe plate, allows you to construct a simple but effective benchtop test station. Available in two sizes and having a 65mm deep pan - allowing some room for any supporting electronics, power supply and wiring.

View all products in this series

Floating Pins

Floating pins for keeping the PCB raised away from the test probes until the top plate is lowered. Also useful for leveling pressure in unpopulated areas. Drill hole size: 2.88 - 2.89mm

View all products in this series

Guide Plates

Guide plates to ensure the alignment of the PCB and to give some protection to the tooling pins & probes.

View all products in this series

Latches

Single latch: top release
Guidelines for single latches:

• Ideal for use with PA4 to PA6 probe ranges
• Suitable for smaller sized PCB’s.
• Receptacles should be mounted into the probe plate, raised high enough to that the probe is suitably compressed when the PCB is latched in place

Double latch: Top release
Guidelines for double latches:

• Adjustable position of both latches
• Suitable for larger PCB sizes
• Ideal for use with PA4 to PA6 probe ranges
• Receptacles should be mounted into the probe plate, raised high enough to that the probe is suitably compressed when the PCB is latched in place

Double latch: Back release
Guidelines for double latches:

• Adjustable position of both latches
• Suitable for larger PCB sizes
• Ideal for use with PA4 to PA6 probe ranges
• Receptacles should be mounted into the probe plate, raised high enough to that the probe is suitably compressed when the PCB is latched in place

View all products in this series

Rigid Tooling Pins

Rigid tooling pins (pegs for locating PCB guide holes)</strong><br />Long length tooling pins, with an M4 thread, suitable for loaded board testing.<br />M4 nuts &amp; washers included. Bullet nose tip.<br /> Drill hole size: 3.95 - 4.00mm

View all products in this series

Pass Marking Unit

A device which, upon receipt of a test pass signal, will scribe a permanent circular mark onto the unit under test