Specialist Test Products >
Micro Test Probes >
PM2 Series >
Non-replaceable. No receptacle. 0.51mm test centres. Drill hole size - 0.34mm to 0.36mm.
The non-replaceable microprobes feature a collar at the top of the barrel, which is used as a stop in the fitment process. Due to the minute barrel diameters and thin walls, it is imperative that the drilled hole diameter (0.34mm - 0.36mm) and straightness are very accurate. We recommend that the pre-wired option is taken as connecting a cable to these probes is an extremely delicate operation.
Usually, multi-plate fixtures containing no less than 3 plates, are used to retain large multiples of probes.
Otherwise a block of stable material which will allow reliable drilled holes is to be recommended, with the microprobe fitted wire/tail first with tweezers, with a small amount of locking compound on the side to secure it, if required.
CODA SYSTEMS LIMITED Oak Road, Little Maplestead, Halstead, Essex, CO9 2RT, United Kingdom | Registered in England No. 1470428
Copyright © 2013