CODA-PIN Contact Probes & Interfacing Components

sales@coda-systems.co.uk
technical@coda-systems.co.uk

Tel: +44 (0)1787 478678
Fax: +44 (0)1787 274194

What are spring contact test probes?
What are Interfacing Components?

CODA SYSTEMS LIMITED
Oak Road, Little Maplestead, Halstead,
Essex, CO9 2RT United Kingdom
Tel: +44 (0)1787 478678
Fax: +44 (0)1787 274194
Email: sales@coda-systems.co.uk

Registered in England No. 1470428

Test Jig Parts

Desktop Test Boxes

Click to show all products in this series

Jig base, consisting of a pan and a hinged probe plate, allows you to construct a simple but effective benchtop test station. Available in two sizes and having a 65mm deep pan - allowing some room for any supporting electronics, power supply and wiring.

Floating Pins

Click to show all floating pins

Floating pins for keeping the PCB raised away from the test probes until the top plate is lowered. Also useful for leveling pressure in unpopulated areas. Drill hole size: 2.88 - 2.89mm

Guide Plates

Click to show all products in this series

Guide plates to ensure the alignment of the PCB and to give some protection to the tooling pins & probes.

Rigid Tooling Pins

Click to show all products in this series

Rigid tooling pins (pegs for locating PCB guide holes)
Long length tooling pins, with an M4 thread, suitable for loaded board testing.
M4 nuts & washers included. Bullet nose tip.
Drill hole size: 3.95 - 4.00mm

Latches

Click to show all products in this series

Single latch: top release
Guidelines for single latches
- Ideal for use with PA4 to PA6 probe ranges.
- Suitable for smaller sized PCB’s.
- Receptacles should be mounted into the probe plate, raised high enough to that the probe is suitably compressed when the PCB is latched in place.

Double latch: Top release
Guidelines for double latches
- Adjustable position of both latches.
- Suitable for larger PCB sizes.
- Ideal for use with PA4 to PA6 probe ranges.
- Receptacles should be mounted into the probe plate, raised high enough to that the probe is suitably compressed when the PCB is latched in place.

Double latch: Back release
Guidelines for double latches
- Adjustable position of both latches.
- Suitable for larger PCB sizes.
- Ideal for use with PA4 to PA6 probe ranges.
- Receptacles should be mounted into the probe plate, raised high enough to that the probe is suitably compressed when the PCB is latched in place.